FDL CAT.6 KEYSTONE PASS THROUGH COUPLER MODULE - BLACK

A pass-through coupler allows you to connect two separate Ethernet cables together by passing the connections through a single module, effectively extending the length of a cable run or joining two segments.

No, this is an unshielded coupler designed for use with unshielded twisted pair (UTP) Ethernet cables.

This CAT.6 coupler supports operation up to 250 MHz, meeting Class E application requirements.

While it may function, this coupler is rated for CAT.6 performance. For optimal results and to guarantee CAT.6 speeds, it is recommended to use it with CAT.6 cables.

The module features a snap-in design and requires punch-down termination on one end, with the other cable passing through to an RJ45 jack. It then snaps into a keystone-compatible panel or plate.

A 1:1 pin configuration means that each pin on one RJ45 jack corresponds directly to the same pin on the other RJ45 jack, maintaining the standard wiring order for Ethernet connections.

Verify that all 8 wires are correctly punched down on both sides of the coupler and that the cable pairs are in the correct order according to the TIA/EIA 568B.2-1 standard. Check that the connected cables are functioning properly.

Ensure the coupler is fully seated in its slot. Check the integrity of the connected Ethernet cables; damaged cables or improper termination can cause performance issues. Confirm that the connected cables are CAT.6 rated.

Check that the keystone slot on the wall plate or patch panel is not damaged and is of standard size. Ensure no obstructions are preventing the coupler from seating correctly.