Cleenly Pool Algae Remover - 5L

For best results and prevention, it is recommended to use Cleenly Pool Algae Remover as a weekly treatment. A weekly dose helps maintain clear water and prevent algae from returning.

The recommended dosage is 10ml of Cleenly Algae Remover per 1000 litres (approximately 264 gallons) of pool water. Always measure carefully for optimal results.

Yes, Cleenly Pool Algae Remover is safe to use in salt water pools, as well as chlorine and bromine pools.

You should typically see a reduction in visible algae within 24-48 hours. The time it takes for complete clarity may vary depending on the severity of the algae bloom and other water conditions.

This product is formulated to treat and prevent all types of swimming pool algae, including green, yellow, and black algae.

Yes, the professional-quality formula is safe for use in all types of swimming pools, including vinyl, fibreglass, and concrete.

If you suspect you have used too much, dilute the pool water by partially draining and refilling, and run the filter system continuously. Consult the product label for specific overdose instructions.

Ensure the correct dosage was used and the pool pump was running for sufficient time. For severe algae, a second dose or a shock treatment might be necessary. Check water balance (pH, alkalinity).

This can sometimes occur as algae breaks down. Ensure your filter is clean and running continuously. It may take a few days for the water to clear completely.

Verify the water volume of your pool to ensure the correct dosage was calculated. Check the expiry date of the product. Algae may be resistant, requiring a different treatment approach or higher concentration.

Ensure the pool water has circulated adequately after application and that the chemical levels are balanced. Rinse eyes or skin immediately with clean water if irritation occurs.