Best current price£72.00from Homebase
Shopping.co.uk recommended and popular offers
Homebase£72.00Visit shop Splashback Clear Glass Kitchen With Brass Caps 900 X 750 X 4Mm
Visit shop
B&Q£99.00Visit shop B&Q - Crystal Clear Toughened Glass Kitchen (Fixing Kit With Brass Caps) 900mm X 750mm X 4mm
Visit shop2 offers from £72.00 - £99.00
View price history by clicking the chart icon.
The Splashback 900 x 750 x 4mm clear glass panel is designed for homeowners and kitchen renovators looking to protect their walls from splashes and heat without obscuring existing decor. By providing a seamless, transparent barrier, it offers a high-end, modern aesthetic that works perfectly over brick, wallpaper, or paint; however, users should be aware that because the glass is completely clear, any imperfections or dust trapped behind the panel will remain visible through the surface.
| Model Part Number | 900 x 750 x 4mm |
|---|---|
| Brand | Splashback |
No. Because the splashback is made from 4mm toughened glass, it cannot be cut or drilled after the tempering process; any attempt to do so will cause the glass to shatter.
Yes, toughened glass is heat-resistant and suitable for use behind gas hobs, provided it is not in direct contact with open flames.
You will need a drill, a masonry or wall-appropriate drill bit, a spirit level for alignment, a screwdriver, and a measuring tape.
A mixture of white vinegar and water or a standard commercial glass cleaner applied with a soft, lint-free cloth will effectively remove water spots.
Yes, it can be mounted over existing tiles, provided the surface is flat enough to allow the glass to sit flush against the wall.
While not strictly required for the glass itself, applying a thin, clear silicone bead along the bottom edge can prevent water or food particles from slipping behind the glass.
Remove the brass caps, take down the panel, clean the wall surface thoroughly with a vacuum and damp cloth, and re-install.
Check that the wall anchors are firmly embedded in the wall and tighten the brass caps until the glass is held securely against the surface.
Installation is designed to be straightforward for DIY enthusiasts. Since the panel comes pre-drilled, identify the exact location on your wall and use a level to ensure the unit is perfectly horizontal. Once aligned, drill the wall anchors using the provided hardware kit.
Before final installation, ensure your wall surface is thoroughly cleaned and dried. Any dust trapped between the glass and the wall will be visible through the clear panel. To care for your splashback, avoid abrasive scouring pads that could scratch the brass caps or leave micro-abrasions on the glass. Use a soft cloth for regular dusting and a standard glass cleaner for deep grease removal.
