Tough Master Tower Heater - 2000W

The Tough Master Tower Heater is designed to efficiently warm rooms up to 20 square meters (215 square feet).

The remote control operates best with a clear line of sight to the heater's LED control panel. Its effective range typically covers a standard room.

The heater includes built-in safety features like tip-over and overheating protection. While designed for safety, it's generally recommended to use the 8-hour timer for automatic shut-off or to turn off the appliance when leaving a room unattended for extended periods.

The `1200W` setting provides a lower, more energy-efficient heat output for maintaining comfort, while the `2000W` setting offers maximum power for rapid heating or warming larger spaces within its recommended range.

The filter should be cleaned regularly, especially during periods of frequent use or if you notice a decrease in heating performance. A general recommendation is every 2-4 weeks, depending on the environment.

No, this heater is not rated for use in bathrooms, laundries, or any other areas with high humidity or where it could come into contact with water. This is crucial for electrical safety.

First, ensure the power cord is securely plugged into a working electrical outlet. Check if the heater has been tipped over; the tip-over protection feature will prevent it from operating. Make sure the desired temperature setting is higher than the current room temperature, and the timer is not set to 'off'.

Verify that the heater is set to the `2000W` high heat setting if maximum warmth is desired. Check the size of the room; the heater is optimized for spaces up to 20m². Ensure the air intake filter is clean, as a clogged filter can reduce heating efficiency. Close doors and windows to prevent heat loss.

Ensure the oscillation button on the control panel or remote has been pressed to activate the feature. Check for any obstructions around the base of the heater that might impede its rotation. If the issue persists, unplug the heater for a few minutes and then plug it back in to reset it.