Jarder Hot Tub System Flush - 2 x 5L

It is recommended to use the system flush at every water change or at least every 3 months, whichever comes first, to maintain the cleanliness of your hot tub's internal pipework.

The recommended dosage is 500ml of the system flush for every 1000L of water in your hot tub.

No, the hot tub should not be occupied or used while the system flush is circulating or soaking in the water. The product is for cleaning the system, not for use with bathers.

After the initial 20-30 minute pump circulation, the solution should be left to soak for at least 3-6 hours, or ideally overnight, for maximum effectiveness.

Yes, it is recommended to rinse the hot tub shell with fresh water and wipe it down to remove any loose debris before refilling with fresh water.

Using significantly more than the recommended dosage is not advised and could lead to excessive foaming or require more thorough rinsing. Always adhere to the 500ml per 1000L guideline.

When used as directed, the formula is designed to be safe for typical hot tub plumbing and components. Avoid prolonged contact with sensitive surfaces if unsure.

Ensure the pumps were running continuously during the initial circulation period and that the recommended dosage was used. For heavily soiled systems, a second application might be considered after a full water change and refill cycle, following the instructions carefully.

This is related to the hot tub's drainage system, not the cleaning product. Ensure your drain valve is fully open and that there are no blockages in the drain line.

Ensure the system was thoroughly flushed during the draining process and that all residual cleaning solution was removed. Double-check that sanitizers were added correctly after refilling with fresh water.