Peel and Stick Herringbone Wall Tile Set - Grey

No, these are peel-and-stick tiles and do not require grout. The design creates a grout-line-free finish.

It is generally not recommended to install directly over wallpaper, especially if it is textured, peeling, or vinyl. For best results, remove the wallpaper and ensure the underlying surface is smooth, clean, and dry.

These tiles offer a durable finish for everyday use in bathrooms. However, they are not as hard-wearing as traditional ceramic tiles and may scratch or chip if subjected to heavy impact.

These tiles are water-resistant and suitable for backsplashes and walls in bathrooms. However, they are not designed for direct, prolonged water exposure such as inside a shower stall or directly behind a bathtub where they will be constantly wet. For such areas, traditional waterproof materials are recommended.

To remove, gently heat the tiles with a hairdryer on a low setting to soften the adhesive. Carefully peel back a corner and pull slowly and steadily. Some adhesive residue may remain and can be cleaned with a mild adhesive remover or soap and water.

You will primarily need a sharp utility knife or scissors for trimming, a measuring tape, and a clean cloth. A level is also recommended for ensuring straight lines.

Each tile is designed to fit into the herringbone pattern. Coverage depends on the number of tiles in the package and the area you wish to cover. Please refer to the product packaging for the exact square footage covered by the set.

Ensure the surface is thoroughly cleaned, dried, and free of dust, grease, or soap scum. For best adhesion, the surface should be smooth. Try using a hairdryer on a low setting to gently warm the tile and the wall before applying pressure.

Start by dry-fitting a few tiles to understand the pattern flow. Use a level to ensure your first row is straight. Trim tiles with a sharp utility knife or scissors if needed for edges or corners, and always measure carefully.

Gently peel back the affected tile immediately after application and reapply, smoothing from the center outwards with firm pressure. If the tile has been in place for a while, you may need to carefully lift a corner and work out the air.

Colors can vary slightly due to screen settings and lighting. Ensure you have opened a tile from the same batch if you are adding to an existing installation. Check the product packaging for batch information.