Shopping.co.uk

Air Intake Temperature Sensor - CI - XEMS252

Air Intake Temperature Sensor - CI - XEMS252

This Air Intake Temperature Sensor is designed for accurate measurement and optimal vehicle perfor...

Best current price£11.99from My Motor World

Best offers

Shopping.co.uk recommended and popular offers

All Offers

12 offers from £11.99 - £18.10

View price history by clicking the chart icon.

My Motor WorldCi Ignition Xems252 Air Temperature Sensor
Free delivery in 1–3 days
£11.99
Visit shop
eBayAir Intake Temperature Sensor fits KIA MAGENTIS 2.5 01 to 05 G6BV Sender CI New
Free delivery in 1–3 days
£18.01
Visit shop

Product Information

Full details

The CI Air Intake Temperature Sensor (XEMS252) is an essential diagnostic component designed for automotive enthusiasts and technicians looking to restore or maintain optimal engine performance in Hyundai, Kia, Daewoo, and Chevrolet vehicles. This sensor delivers precise thermal data to the engine control unit to regulate air-fuel ratios, ensuring efficient combustion and consistent power delivery. While this sensor is engineered for high reliability, users must verify their vehicle's specific OEM part number compatibility before purchase to ensure proper installation and electrical communication with the engine management system.

All features

Model Part NumberXEMS252
BrandCI

Extended Product Information

FAQs

What vehicles are compatible with the XEMS252?

It is designed for various models from Hyundai, Kia, Daewoo, and Chevrolet. Always cross-reference your OEM number.

Do I need special tools to install this sensor?

No, a standard 21mm wrench or deep-well socket is typically sufficient for installation.

Will a faulty sensor cause my car to fail emissions?

Yes, an incorrect temperature signal can cause the engine to run too rich, which may increase tailpipe emissions.

Can I clean this sensor if it gets dirty?

While you can gently clean the external housing, it is recommended to replace the sensor if the internal element is contaminated or damaged.

Is the thread size universal for all sensors?

No, this specific model features an M14 x 1.5 thread; ensure this matches your intake manifold port.

Troubleshooting

Check Engine Light persists after replacement

Clear the fault codes using an OBD-II scanner after installation to reset the ECU learning parameters.

Rough idle immediately after installation

Ensure the 2-pin connector is fully seated and clicked into place to prevent poor electrical contact.

Pros and Cons

Pros

  • Ensures accurate air-fuel mixture optimization
  • Direct OEM-replacement fitment for specific models
  • High-grade thermal response time
  • Rugged build quality for long-term reliability

Cons

  • Requires specific vehicle compatibility verification
  • Installation requires access to the intake manifold
  • Sensitive electrical component requires careful handling

Setup, Compatibility & Care

To install, ensure the engine is completely cool to avoid thermal injury. Locate the existing intake temperature sensor on the air intake tract or manifold. Disconnect the 2-pin wiring harness, use a 21mm wrench to carefully unscrew the old sensor, and thread the new XEMS252 into place. Do not over-tighten, as the thread pitch of M14 x 1.5 is designed to seal without excessive force.

Compatibility Note: This part replaces various OEM references including 392302F000 and 96508200. Always check your vehicle owner's manual or scan tool data to verify that your specific engine trim requires this exact sensor. Keep the sensor tip clean from oil or debris during installation, as contaminants can cause inaccurate temperature readings.

Price History

DatePrice
Visit shop