Kitchen Cabinet - Kitchen Kit - Shaker Matt Cashmere - Double Extractor Wall - 800mm

With the glue and click system, basic cabinet assembly can take as little as 30 seconds, not including adhesive curing time.

This wall unit features an 18mm rear service void for concealing necessary pipes and wiring.

Yes, the doors can be hinged on either the left or right side to suit your kitchen configuration.

The product usually comes with the specific adhesive required, or instructions will specify the type needed. Follow the included guide precisely.

Mounting brackets are included for installation, but appropriate wall fixings (screws, wall plugs) suitable for your wall type are not typically included and must be sourced separately.

Wipe clean with a soft, damp cloth. Avoid abrasive cleaners or harsh chemicals to maintain the finish.

The 18mm MFC cabinet with an 8mm back provides good rigidity. However, ensure it is securely mounted to the wall, and be mindful of weight distribution, especially for wall units.

Ensure adhesive was applied evenly and generously to all joining surfaces. Confirm pieces were pressed together firmly and held until the initial bond set. Allow the adhesive to cure for the full recommended time.

Check that the hinges are correctly installed on both the door and the cabinet. Adjust the hinge screws to fine-tune the door alignment. Ensure the cabinet itself is mounted level on the wall.

Verify that the hinges are correctly fitted and not obstructed. Ensure the door is not excessively heavy for the hinges or binding against the cabinet frame. Check if any packing material is still present within the hinge mechanism.

Plan your cable or pipe routing before final assembly if possible. Use the void strategically, and consider conduit or trunking if a large amount of wiring needs to be concealed.