CarPlan Engine Lacquer - Matt Black - 250ml

Touch dry in approximately 20 minutes, and fully cured in 24 hours, but allow longer under cooler or humid conditions. Always apply subsequent coats within specified recoat times if possible.

While heat-resistant, this lacquer is primarily designed for engine block inlets and similar components. For high-heat exhaust components, a dedicated high-temperature exhaust paint is generally recommended.

Typically, 2-3 thin, even coats are recommended for optimal coverage and durability. Avoid applying too thickly.

This product is intended for metal surfaces. Compatibility with plastics can vary; it is recommended to test on an inconspicuous area first or use a specialized plastic primer and paint system.

Wet overspray can usually be wiped away with a cloth and appropriate solvent (check product label). Dried overspray may require gentle polishing or wet sanding, depending on the surface.

After use, turn the can upside down and spray for a few seconds to clear the nozzle. Store upright in a cool, dry place away from direct sunlight and sources of ignition.

Apply thinner coats from a consistent distance. Ensure the can is adequately shaken before and during use. Reduce spraying speed if the paint is not flowing evenly.

Applied too thickly or from too close. Stop spraying, allow to dry slightly, and gently wipe away excess with a clean cloth before reapplying in thin coats.

Surface was not properly cleaned or prepared. Ensure all grease, oil, and contaminants were removed. Lightly abrading the surface before application can improve adhesion.

The nozzle may be partially blocked. Try clearing the nozzle with a fine-point tool or rotating the nozzle. Ensure the can was shaken sufficiently.