Dovetail Joint Jig - 300mm - Lumberjack Tools

You can cut 1/2" wide half blind or rebated dovetails.

The jig is designed for use with small to medium-sized routers, up to approximately 150mm in diameter.

No, you will need to purchase a dovetail router bit separately.

Clean the jig with a brush or cloth to remove wood dust. Avoid using solvents that could damage the jig.

This jig is designed specifically for half-blind and rebated dovetails. It's not suitable for through dovetails.

The jig is suitable for use with a variety of hardwoods and softwoods.

Minor assembly and setup are required; the jig comes with instructions to guide you through the process.

Check the router bit's depth and the jig's settings. Fine-tune the settings and make test cuts on scrap wood.

Ensure your router is within the size and diameter limitations of the jig (up to 150mm).

Check the quality of your router bit. Ensure the wood is properly supported during the cut, and adjust the feed rate.