Aurora Mestor CWS LED Bulkhead - White

Turn off the power supply. Carefully remove the diffuser. Inside the base, you will find small switches to select between 3000K, 4000K, 6500K for color temperature, and 12W, 16W, 20W for wattage. Set the switches to your desired options before reattaching the diffuser and restoring power.

No, the emergency lighting packs and the microwave corridor sensing pack are sold separately as optional accessories. They must be purchased in addition to the main LED bulkhead.

The Aurora Mestor CWS LED Bulkhead comes with a 5-year warranty, providing peace of mind for your lighting investment.

Yes, the bulkhead has an IP65 rating, which means it is protected against dust and low-pressure water jets, making it suitable for outdoor or exposed locations.

An IK10 rating signifies a high level of protection against mechanical impacts. This fixture can withstand an impact energy of up to 20 joules, equivalent to a 5kg mass dropped from approximately 40cm, offering resistance to vandalism and accidental damage.

The LED module is integrated and not designed to be user-replaceable. For failures occurring outside the 5-year warranty period, replacement of the entire fixture would typically be required.

The fixture requires a standard 230V mains power connection. It is designed for direct wiring into your electrical system.

Check that the main power supply is switched on and correctly connected to the fixture. Verify the circuit breaker hasn't tripped. Ensure internal switches for wattage and color temperature are correctly set.

The color temperature switch inside the fixture may not have been set correctly during installation. Turn off power, remove the diffuser, and adjust the color temperature switch to the desired setting (3000K, 4000K, or 6500K).

The wattage switch inside the fixture may need adjustment. Turn off power, remove the diffuser, and set the wattage switch to the desired level (12W, 16W, or 20W).

Ensure the compatible accessory pack is correctly installed and wired according to its manual. Verify that the power supply to the accessory pack is active. If using a sensor, check for obstructions and ensure correct sensitivity settings.