Rasch Wallpaper - Floral - Grey

Use a high-quality adhesive specifically recommended for non-woven (fleece) wallpapers and the 'paste the wall' application method.

Measure the height and width of your walls. Divide the total width by the width of the roll (53cm) to get the number of strips. Account for the pattern repeat. It's always recommended to buy an extra roll to ensure consistency and for future repairs.

Yes, non-woven wallpapers with the 'paste the wall' application are typically strippable when dry. You can usually peel them off in large sections.

The wallpaper can be wiped clean with a damp cloth. It is not considered fully washable like vinyl wallpapers, so avoid heavy scrubbing or excessive moisture.

A straight match means that the pattern on one strip of wallpaper aligns horizontally with the pattern on the adjacent strip. This is the simplest type of pattern match.

It is generally not recommended to hang wallpaper over existing wallpaper, especially if the old paper is vinyl or has a pattern. The surface should be smooth, clean, and sound. Remove old wallpaper first.

Gently lift the affected section and re-smooth it with a wallpaper brush, working from the center outwards. Ensure adhesive was applied evenly to the wall.

Slightly adjust the position of the strip while the adhesive is still wet. For future strips, re-check the straight match alignment.

Wipe immediately with a clean, damp cloth. Do not rub vigorously. Ensure you are using the correct type of adhesive for non-woven wallpaper.

Use a very sharp utility knife or a snap-off blade knife. Make sure the blade is fresh for a clean cut. Trim carefully along the edge of a straight edge or ruler.