Disc Plate Hanger - 75mm Adhesive

The 75mm Disc Plate Hanger is designed for plates up to 8" in diameter.

It is suitable for porcelain, china, glass, and similar materials.

Removing the hanger without damaging the plate or wall can be tricky. Try gently warming the adhesive with a hairdryer to soften it. Then carefully work a thin, flat tool (like a spatula) between the hanger and the wall/plate.

The adhesive is designed for single use. It's best to use a new hanger for each item. Replacement adhesive can be purchased if you need to rehang the plate.

Allow the adhesive to set for the time recommended on the product packaging, typically a few hours or overnight, for the best adhesion.

The hanger is designed for smooth, flat surfaces. If your wall is textured, the adhesion might be compromised. Test a small area first, or consider an alternative hanging method.

The hanger is designed for plates and decorative items within the specified weight limits. Please check the product packaging for precise weight capacity.

Ensure both the plate and wall surfaces were thoroughly cleaned and dried before application. Check the adhesive for proper contact and allow adequate setting time. Consider using a different adhesive if necessary.

Carefully center the hanger on the plate and ensure it is not protruding from behind the item. For lighter plates, consider using a smaller hanger or adjusting the placement to minimize visibility.

Make sure the surfaces are clean, dry, and free of any residue. The room temperature may affect the adhesive performance. Ensure the item is not too heavy for the hanger.