Best current price£8.98from Amazon
Shopping.co.uk recommended and popular offers
Amazon£8.98Visit shop Igad Black 8Mm Push-In Tap For Water-Fed Brush Hose – In-Line On/Off Valve For Water-Fed Pole Systems
Visit shop3 offers from £8.98
View price history by clicking the chart icon.
The IGAD 8mm Push-In Tap is designed for users of water-fed brush hose systems, offering precise control over water flow. Its key benefit is enhancing cleaning efficiency by allowing quick pauses to start or stop water flow without disrupting your workflow. A potential caveat is its specific fit for 8mm hoses, requiring users to confirm compatibility with their existing setup. This in-line valve is an essential accessory for maintaining optimal water management during professional or home cleaning tasks.
| Model Part Number | UKIP90 |
|---|---|
| Brand | IGAD |
The tap is designed for 8mm diameter hoses. Check the specifications of your current water-fed brush hose. If it states 8mm internal diameter, it should be compatible.
No, the IGAD Push-In Tap is designed for tool-free installation. You will only need a clean, sharp tool to cut your hose squarely.
While it's designed for in-line use, adding too many accessories can affect water pressure. It's best used directly on the main hose run for optimal performance.
Use a damp cloth to wipe the exterior. For internal cleaning, you can flush it with clean water. Avoid using harsh chemicals or abrasive materials.
The tap is designed to have minimal impact on water pressure when fully open. However, any in-line fitting can cause a slight reduction. Its main function is to control flow, not to boost pressure.
The push-in fittings are designed to create a secure, leak-free seal under typical water-fed pole operating pressures. Ensure the hose is properly seated for maximum durability and reliability.
Ensure the hose is fully and squarely inserted into the push-in fitting. Check the hose for any nicks or damage at the cut end that might prevent a proper seal. Re-cut the hose if necessary and reinsert firmly.
Check for any debris or sediment around the valve mechanism. Rinse the tap with clean water. If the issue persists, inspect for any internal obstructions.
Confirm that the hose diameter is indeed 8mm and that the tap is fully open. Check the hose for kinks or blockages. Ensure the tap itself is not obstructed internally.
Verify that the valve is turned to the fully closed position. Check for any debris lodged within the valve seat that may be preventing a complete seal. If damage is suspected, replacement may be necessary.
Setup: To install the IGAD Push-In Tap, first ensure your water-fed brush hose is 8mm in diameter. Locate the desired position on the hose, typically near the base of the water-fed pole. Cut the hose cleanly at this point. Firmly push one end of the hose onto one of the tap's push-in fittings. Then, push the other end of the cut hose onto the remaining fitting. Ensure both connections are fully seated for a secure, leak-free seal.
Compatibility: This tap is designed to work with standard 8mm water-fed brush hoses. It is fully compatible with IGAD water-fed pole systems and is generally suitable for most other brands utilizing 8mm hoses. Verify your hose diameter before purchase.
Care: After each use, it is recommended to rinse the tap with clean water to remove any debris that may have accumulated. Periodically check the push-in fittings for any signs of wear or blockage. To clean the exterior, use a damp cloth; avoid abrasive cleaners. Ensure the tap is completely dry before storing.
